|
Type
Problem
|
Test
Conditions
|
|
|
|
Set Outfeed to drop 0.022 in 15 inches, approximate
depth of cut 1/16 inch
|
|
|
|
Set
Outfeed to rise up 0.025 in 15 inches, approximate depth
of cut 1/16 inch
|
|
|
|
Set Outfeed
Table Up 0.006 inches (Higher than cutter head), approximate
depth of cut 1/16 inch.
This produced a taper, only first 10 inches of
48 inches was cut.
|
|
|
|
Set Outfeed Table Up 0.003 inches (Higher
than cutter head), approximate depth of
cut 1/16 inch.
This produced a taper, only first
33 inches of 48 inches was cut.
When set on 123 blocks this appeared
to have a bow down but was due to one end
setting on cut portion and the other end
on uncut portion.
|
|
|
|
Set Outfeed Table down
0.012 inches (Lower than cutter head), approximate depth
of cut 1/16 inch.
|
|
